XY-P15W Stereo Bluetooth Power Digital Amplifier Board 12V/24V 10W/15W/20W

Specification:
Output Power(at 1KHz):
Output power 16W*2 at 12V 4ohm
Output power 10W*2 at 12V 8ohm
Output power 15W*2 at 16V 4ohm
Output power 20W*2 at 20V 4ohm
Output power 30W*2 at 24V 4ohm(Need add extra heat sink!)
Match speaker(30W~150V):
4ohm at 8V~12V
8ohm at 8V~24V
16ohm at 8V~24V

Use steps:
1.Choose the right speaker and connect as shown in wiring diagram.
2.Connect to right power supply from input terminal.LED indicator will flashing and it means that module enters pairing mode.And then speak prompt voice and it means that module is waiting for pairing.
3.Turn ON Bluetooth in phone.
4.Select Bluetooth device XY-P15W in your Bluetooth device listing.
5.LED indicator will keep ON and it means that module is successfully connected and is waiting for playing.
6.Module will playing music after select music in phone.LED indicator will keep slowly blinking.
7.Module will speak prompt voice if disconnected.

Application:
Modified speaker
Amplifier equipment
Car Bluetooth device

Note:
1.The power amplifier board should be as far away as possible from the WIFI signal (router) avoid signal interference.
2.Recommended power supply voltage DC 8~24V.Module will be damaged if input voltage is more than 26V.
3.Input voltage can not more than 12V if connect 4 ohm speaker.
4.Input voltage can not more than 24V if connect 8 ohm speaker.
5.It is recommended to use a power supply of 2A or higher.
6.It need add extra heat sink if output power is more than 20W*2.
7.Please don’t use too long wires to avoid signal interference.
8.It is recommended to use a speaker above 30W to avoid speaker damage.

Package Included:
1 x XY-P15W Stereo Bluetooth Power Digital Amplifier Board 12V/24V 10W/15W/20W
1 x Acrylic sheet with mounting screws
Instructions/schematic are NOT included. We don’t provide technical assistance please make sure that you are familiar with the product before purchasing.